4.29 canc-lpo

Use this command to cancel a processor outage and restore the link to its previous state. LSSUs with status of processor outage are terminated, and the link begins sending MSUs.

Note:

The signaling link’s blocked status is not preserved across a card reboot.

Parameters

link (mandatory)
The signaling link defined on the card specified in the loc parameter. The links can be specified in any sequence or pattern.
Synonym:
port
Range:
a, b, a1 - a63, b1 - b63

Not all card types support all link parameter values.

See Table A-1  for valid link parameter range values for each type of card that can have a location specified in the loc parameter.

loc (mandatory)
The address of the card containing the signaling link to be unblocked.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

canc-lpo:loc=2311:link=b

Dependencies

A card location must be specified that is valid and defined in the database.

No other action command can be in progress when this command is entered.

The value specified for the loc parameter must refer to one of the following cards, and the referenced card must be equipped:

  • E5-E1T1-B, card running the SS7ANSI or CCS7ITU application
  • E5-ATM-B card running the ATMANSI or ATMITU application
  • E5-ENET-B card running the IPLIMI, or IPSG application
  • SLIC card running the IPSG application

The card must contain signaling links.

The signaling link must be equipped in the database.

This command is not valid for links belonging to proxy linksets.

An appropriate value must be specified for the link parameter when an ATM card is used:

  • a-a1, b—E5-ATM-B card running the ATMANSI or ATMITU application

canc-lpo command is not supported for links associated with J7 APCs.

This command is not valid for IPSG-M3UA signaling links.

Notes

The function of this command is the same as the ublk-slk command.

Unblocking a signaling link removes a Level 2 failure resulting from a blk-slk of an ATM high-speed signaling link.

Installation Guide provides an illustration of card locations.

Output

canc-lpo:loc=2311:link=a 

    tekelecstp 05-01-21 17:00:36 EST  EAGLE5 33.0.0
    Local processor outage being cleared. 
;

In the following example, card location 1113 is not valid:

canc-lpo:loc=1113:link=a 

    tekelecstp 05-01-21 17:00:36 EST  EAGLE5 33.0.0
    Command Rejected : Location is not valid for command 
;
act-lpo
blk-slk
ublk-slk