4.43 chg-clkopts

Use this command to perform a software update of the clock elements and settings.

Parameters

clock (mandatory)
Clock to be updated.
Range:
all
all clocks
primary
primary clock
secondary
secondary clock

E5-TDM cards must be installed before a value of  primary or secondary can be specified.

force (optional)
The force=yes parameter is used to change the hsclksrc parameter value when the TDMs are reporting that the high speed system clocks are currently valid.
Range:
yes
hsclkll (optional)
High speed master clock line length.
Range:
longhaul
Gain is high for long haul
shorthaul
Gain is low for short haul
Default:
No change to the current value
System Default:
longhaul
hsclksrc (optional)
High speed master clock source. The force=yes parameter must be specified with this parameter to change the clock source when the TDMs are reporting that the high speed system clocks are currently valid.

Caution:

Changing the high speed master clock source can result in clock outage and loss of traffic on all links, if the new source type does not match the provisioned source for the E1 or T1 cards (what is actually plugged into the backplane).
Range:
e1framed
E1 Framed clock source
e1unframed
E1 Unframed clock source
rs422
RS-422 clock source
t1framed
T1 Framed clock source
t1unframed
T1 Unframed clock source
Default:
No change to the current value
System Default:
rs422

Example

chg-clkopts:clock=primary:hsclksrc=t1framed

chg-clkopts:clock=all:hsclksrc=rs422:force=yes

chg-clkopts:hsclkll=shorthaul:clock=secondary

Dependencies

The STPOPTS table is corrupt or cannot be found.

The parameters entered are not compatible with the card where the clock resides.

If the hsclksrc and clock=all parameters are specified, and the high speed clocks are reporting, then the force=yes parameter must be specified.

Notes

None.

Output

chg-clkopts:clock=primary:hsclksrc=t1framed

    e5oam 09-01-01 17:25:22 MST  EAGLE 40.1.0
    CHG-CLKOPTS: MASP B - COMPLTD 
;