4.182 dact-rstst

Use this command to request deactivation of the routeset test being performed by the LIMs running the ss7ansi application. The system verifies that the point code and the linkset exist, and that the specified linkset is in the routeset of the specified point code. If it is, then a request to stop routeset testing procedures for the specified destination-linkset combination is sent to the LIM.

Parameters

dpc (mandatory)
The ANSI destination point code of the destination, x-list entry, or cluster whose routeset testing is to be stopped, with subfields network indicator-network cluster-network cluster member (ni-nc-ncm).
Synonym:
dpca
Range:
000-255

Specify a valid value for each subfield of the point code, and separate the subfields with a dash (-).

When chg-sid:pctype=ansi is specified, ni = 000 is not valid.

When chg-sid:pctype=ansi is specified, nc = 000 is not valid if ni = 001–005.

When chg-sid:pctype=ansi is specified, nc = 000 is valid if ni = 006–255.

The point code 000-000-000 is not a valid point code.

lsn (mandatory)
The name of the linkset associated with the destination point code that is to have routeset testing stopped.
Range:
ayyyyyyyyy

1 alphabetic character followed by 9 alphanumeric characters

Example

dact-rstst:dpc=1-2-*:lsn=lsn1a

dact-rstst:dpc=1-2-33:lsn=lsn1b

Dependencies

The specified DPC must be either provisioned or an x-list entry.

The specified linkset must be in the DPC’s routeset.

The destination address must be a full point code or a cluster point code specified as ni-nc-*. A DPC cannot be specified as ni-nc-** or ni-nc-*** for the this command.

The specified linkset must exist in the linkset table.

Notes

None

Output

dact-rstst:dpc=1-2-*:lsn=lsn1a

    rlghncxa03w 04-01-05 16:40:40 EST  EAGLE 31.3.0
    Stop routeset testing request sent to SNM (scroll area)

    rlghncxa03w 04-01-05 16:40:40 EST  EAGLE 31.3.0
    Command Completed. 
;