4.183 dact-slk

Use this command to change the state of the specified link to OOS-MT-DSBLD (out-of-service maintenance-disabled).

Caution:

This command impacts network performance, and should be used only during periods of low traffic.

Parameters

link (mandatory)
Signaling link on the card specified in the loc parameter. The signaling links can be specified in any sequence or pattern.
Synonym:
port
Range:
a, b, a1 - a63, b1 - b63

Not all card types support all link parameter values.

See Table A-1  for valid link parameter range values for each type of card that can have a location specified in the loc parameter.

loc (mandatory)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

dact-slk:loc=1301:link=a

Dependencies

Valid IMT bus entries are "A" or "B".

A card location must be specified that is valid and defined in the database.

No other action command can be in progress when this command is entered.

The value specified for the loc parameter must refer to one of the following cards, and the referenced card must be equipped:

  • E5-E1T1-B, or HC MIM card running the SS7ANSI or CCS7ITU application
  • E5-ATM-B card running the ATMANSI or ATMITU application
  • E5-ENET-B card running the IPGWI, IPLIMI, IPSG, or SS7IPGW application
  • SLIC card running the IPSG application

The card must contain signaling links.

The signaling link must be equipped in the database.

The card must be equipped in the specified card location.

An appropriate value must be specified for the link parameter when an ATM card is used:

  • a-a1, b—E5-ATM-B card running the ATMANSI or ATMITU application

This command is not valid for IPSG-M3UA signaling links.

Notes

Installation Guide provides an illustration of card locations.

After the dact-slk command is entered, verify the cancellation by issuing the rept-stat-slk command.

Output

dact-slk:loc=1301:link=a

    rlghncxa03w 04-01-07 11:11:28 EST  EAGLE5 33.0.0
    Deactivate Link message sent to card 
;