4.633 unhb-slk

Use this command to return an inhibited signaling link to service. If the link was aligned when it was inhibited, a changeover occurred. This command causes a changeback on the specified link. MSUs are transmitted on the link after the changeback is issued.

Note:

The inhibited status of the signaling link is not preserved across a LIM reboot.

Parameters

link (mandatory)
The signaling link on the card specified in the loc parameter. The signaling links can be specified in any sequence or pattern.
Synonym:
port
Range:
a, b, a1 - a63, b1 - b63

Not all card types support all link parameter values.

See Table A-1 for valid link parameter range values for each type of card that can have a location specified in the loc parameter.

loc (mandatory)
The card location as stenciled on the shelf of the system.
Range:
1101 - 1108, 1111 - 1112, 1201 - 1208, 1211 - 1218, 1301 - 1308, 1311 - 1318, 2101 - 2108, 2111 - 2118, 2201 - 2208, 2211 - 2218, 2301 - 2308, 2311 - 2318, 3101 - 3108, 3111 - 3118, 3201 - 3208, 3211 - 3218, 3301 - 3308, 3311 - 3318, 4101 - 4108, 4111 - 4118, 4201 - 4208, 4211 - 4218, 4301 - 4308, 4311 - 4318, 5101 - 5108, 5111 - 5118, 5201 - 5208, 5211 - 5218, 5301 - 5308, 5311 - 5318, 6101 - 6108, 6111 - 6118

Example

unhb-slk:loc=1301:link=a

Dependencies

A card location that is valid and defined in the database must be specified.

No other action command can be in progress when this command is entered.

The value specified for the loc parameter must refer to one of the following cards, and the referenced card must be equipped:

  • E5-E1T1-B card running the SS7ANSI or CCS7ITU application
  • E5-ATM-B card running the ATMANSI or ATMITU application
  • E5-ENET-B card running the IPLIMI, or IPSG application
  • SLIC card running the IPSG application

The card must contain signaling links.

The signaling link must be equipped in the database.

The inhibit and uninhibit actions are valid for links on E5-ENET-B cards running the IPLIMx application.

The card in the specified card location cannot be an E5-TDM card, an E5-MDAL card, a MUX card, or the cards running the OAM application.

This command is not valid on E5-ENET-B cards with SS7IPGW, IPGWI, or IPSG-M3UA links. IPLIMI links can be uninhibited.

If an IPSG-M3UA signaling link is used, then this command cannot be entered.

An appropriate value must be specified for the link parameter when an ATM card is used:

  • a-a1, b—E5-ATM-B card running the ATMANSI or ATMITU application

This command is not supported for links associated with J7 APCs.

Notes

The function of this command is the same as the canc-lpo command.

Installation Guide provides an illustration of card locations.

Output

unhb-slk:loc=1301:link=a

    rlghncxa03w 03-03-23 13:20:59 EST  EAGLE 31.3.0
    Allow Link message sent to card 
;