4.259 dlt-shlf
Use this command to remove a shelf from the system database.
Parameters
Example
dlt-shlf:loc=2300
dlt-shlf:loc=6200
Dependencies
The frame and shelf values of the shelf location parameter (loc) must be within the valid range (xyzz, where x=frame and y=shelf; zz is always 00 for this command).
The equipment shelf must have been configured previously.
The specified shelf cannot have any configured cards.
The Shelf table is corrupt or cannot be found by the system.
The IMT table is corrupt or cannot be found by the system.
If the equipment shelf is the only provisioned shelf in the frame and a frame power threshold entry is configured in the Frame Power Threshold table for the frame, the shelf cannot be deleted until the frame power threshold entry is deleted from the Frame Power Threshold table.
Notes
All shelves in the system can be removed, except the control shelf (1100).
Before a shelf can be removed from the database, all SS7 signaling links and TCP/IP data links must be deactivated and removed from the database and all cards in the shelf must be removed from the database. See Database Administration - System Management User's Guide for more information on shelf removal.
Refer to Installation User's Guide for an illustration of shelf locations.
Output
dlt-shlf:loc=2300
rlghncxa03w 04-01-07 11:11:28 EST EAGLE 31.3.0
DLT-SHLF: MASP A - COMPLTD
;
dlt-shlf:loc=6200
tekelecstp 03-09-12 11:11:28 EST EAGLE 45.0.0
DLT-SHLF: MASP A - COMPLTD
;