ent-subnetid

Use this command to enter elements into the Subnet ID list, for the ISUP NP with EPAP feature. Each entry is identified by the Subnet ID and the Subnet number.

The Subnet ID length (subnetidlen parameter) must be entered first, before the command is entered the second time to enter the Subnet ID and Subnet Number.

Parameters

subnetid (optional)

Vendor Subnet ID

Range:: 1 - 15 digits
Valid digits are 0-9, a-f, A-F.

Note:
The number must contain the number of digits defined by the subnetidlen parameter.

subnetidlen (optional)

Subnet ID Length.

Range:: 1 - 15
All Subnet IDs defined for the ISUP NP with EPAP feature must contain this number of digits.

subnetnum (optional)

Subnet Number. A reference to the prefix number for the ISUP NP with EPAP feature (see the chg-prefix command).

Range:

1: Corresponds to the prefix defined with prefix number 1
2: Corresponds to the prefix defined with prefix number 2
3: Corresponds to the prefix defined with prefix number 3
4: Corresponds to the prefix defined with prefix number 4
5: Corresponds to the prefix defined with prefix number 5

Example

ent-subnetid:subnetidlen=6

ent-subnetid:subnetid=886933:subnetnum=1

Dependencies

The value none cannot be specified for the subnetid parameter.

The ISUP NP with EPAP feature must be enabled before this command can be entered.

The SUBNETID table can contain a maximum of 50 entries.

The specified ID entry cannot already exist in the SUBNETID table.

The SUBNETID table is corrupt or cannot be found by the system.

All SUBNETID table entries must have the number of digits defined by the subnetidlen parameter value.

The prefix with the same prefix number as the specified Subnet Number must already be provisioned for the ISUP NP with EPA feature.

The Subnet ID length cannot be changed unless the SUBNETID table is empty. All Subnet IDs must be deleted from the table before a different Subnet ID length can be entered.

The Subnet ID length must be entered before any Subnet IDs can be defined.

The subnetidlen parameter cannot be specified in the same command with the subnetid and subnetnum parameters.

Notes

None.

Output

The Subnet ID length must be entered first.

ent-subnetid:subnetidlen=6


    rlghncxa03w 04-10-07 11:11:28 EST  EAGLE 31.11.0
    ENT-SUBNETID: MASP A - COMPLTD 
;

The first Subnet ID and Subnet number can be entered after the Subnet ID length has been entered.

ent-subnetid:subnetid=886933:subnetnum=1


    rlghncxa03w 04-10-07 11:11:28 EST  EAGLE 31.11.0
    VENDID table is (6 of 50) 11% full
    ENT-SUBNETID: MASP A - COMPLTD 
;

4.357 ent-subnetid