4.458 rtrv-atm-prm

Use this command to display system-wide non-configurable ATM layer parameters for each ATM high-speed signaling link. The data displayed includes the ATM interface parameters and the ATM traffic descriptor values.

Parameters

This command has no parameters.

Example

rtrv-atm-prm

Dependencies

None

Notes

None

Output

rtrv-atm-prm

    tekelecstp 04-02-05 08:40:18 EST  EAGLE 31.3.0
    DS1   DS1   E1    E1                    MAX   MAX   VCI   VPI
    PCR   SCR   PCR   SCR   BT   CDVT  QOS  VPCs  VCCs  BITS  BITS
    3622  3622  4528  4528  210  100   3    0     1     16    12   
;

Legend

The ATM traffic descriptors are displayed in the following fields:

  • BT—Burst tolerance. The number of consecutive cells on the VCL permitted on the ATM interface by the enforcement process, given the PCR and the line speed.
  • CDVT—The amount of cell delay variation for the VCL in the network ingress direction.
  • PCR—The maximum or peak cell rate for the VCL (virtual channel link) T1 is for ANSI and E1 is for ITU.
  • QOS—Quality of service. The performance objectives that must be met by the ATM VCL when it must discard cells during enforcement of the traffic parameters.
  • SCR—The average or sustainable cell rate supported on the VCL. T1 is for ANSI and E1 is for ITU.
  • The ATM interface parameters are displayed in the following fields:
  • MAX VCCs—The maximum number of simultaneously active Virtual Circuit Connections (VCCs) supported.
  • MAX VPCs—The maximum number of simultaneously active Virtual Path Connections (VPCs) supported (by the ATM interface).
  • VCI BITS—The number of allocated VCI bits to be used in the VPIs in the ATM cells for the VCLs supported on the ATM interface.
  • VPI BITS—The number of bits to be used in the VPIs in the ATM cells for the VPLs terminated on the ATM interface.

Related Topics