Resolved Bug List
The table in this section lists the bugs resolved in the following build:
- EAGLE 48.0.0.0.0-80.29.0
The resolved bug table shows an impact statement for the severity 1 and 2 bugs as well as severity 3 bugs associated with an SR.
Note:
Resolved bugs are sorted in ascending order by severity and then by bug number.Table 8-1 EAGLE Release EAGLE 48.0.0.0.0-80.29.0 Resolved Bugs (December 2025)
| Bug Number | SR | Severity | Title | Customer Impact |
|---|---|---|---|---|
| 36819377 | Y | 2 | ACTIVE Partition of MASP becomes inaccessible after re-initializing MASP card | If this issue occurs, the Eagle database on the E5-MASP card will become inconsistent, report DMS errors for reading/ writing Eagle database tables, and fail to connect to the IMT buses when the card is booted. |
| 37186157 | Y | 2 | SCCP cards reboot with "Module ath_vxw_mgr. Line 2057 Class 01c3" out of the blue and reload the RTDB.
|
SCCP card reboots could cause loss of SCCP traffic while card recovers. |
| 37844573 | Y | 2 | Problem in the EPAP log files after EAGLE upgraded to 47.1 | No impact to customer. |
| 29883833 | N | 3 | Eagle Upgrade Document E54340 Recovery C does not account for using the spare MASP as the recovery | |
| 31186470 | N | 3 | 46.9:- clc_mgr.c, clc_utl.c and scm_ldr.c severity 1 are being observed on Eagle
|
|
| 32215034 | Y | 3 | DB Audit running for more time in 46.9.0 due to addition of CAT2 feature | Customers need to execute a system backup post upgrade and want to do this during the upgrade maintenance window. The increased DB audit time delays normal system administration up to 90 minutes. |
| 33156426 | Y | 3 | R47.0_ST: chg-assoc is allowing configuration of assoc to exceed Assoc Buffer Space from Available Buffer Space | chg-assoc command allows configuration of assoc to exceed association buffer size from available buffer space on the card. This may result in card getting into auto-inhibited state. However, ent-assoc command has a check to verify the available buffer space when association is created.
|
| 33252307 | N | 3 | R47.0_ST: M3UA link is catering traffic more than its configured maxslktps if maxslktps is less than 200
|
|
| 35148389 | N | 3 | R47.1_DEIR_FT:LINK1 LED turn red when IP port not configured | |
| 35328317 | Y | 3 | R47.1_ST: USB detection gets stopped after execution of few commands | There is no traffic loss because of this issue. These are debug commands that should only by used by Oracle. |
| 35380043 | N | 3 | R47.0_MR:Inconsistency in traceroute |
|
| 35694509 | N | 3 | R47.1_ST:Observing severity1 t4v_msg.c from line 937 and 939 on SCCP cards
|
|
| 35772576 | Y | 3 | R47.1_ST: Module mfctkapi.c Line 3944 Class 01c3 Severity 1 observed on SCCP cards
|
No impact on the traffic and functionality of the application. This generally happens when there is high traffic received on the card which marks MFC service in flow control. |
| 35850604 | N | 3 | R47.1_ST: Recovery C:Observed Severity1 trp.c on SCCP card
|
|
| 35878922 | N | 3 | R47.1_OBIT "Module restart.c Line 1608 Class 0001" is observed on SIP and ENUM cards while warm restart.
|
|
| 35937011 | Y | 3 | R47.1_ST: DB Inconsistent and Severity 1 "radb_ip.c" observed on SFLOG and IPSM card when static route is entered
|
If a static IP route for an IPSM card is deleted, this will cause the card to go into a DB-DIFF state. This can be resolved by initializing the IPSM card. Routes are generally deleted on IPSM cards when there is a change in the local network which may or may not require a new route to be added. If the local IP is changed then the card must be inhibited which then resets the netstat table and resolves the DB-DIFF state.
|
| 36164708 | Y | 3 | Disable all ORACLE Unacceptable SSH Ciphers | SSH clients must use one of the updated ciphers to SSH to Eagle. |
| 36303298 | Y | 3 | SFAPP-related UIM Reasons could not be found in @documentation | No customer impact. |
| 36624440 | N | 3 | R47.0.0.1_CAT2: Standby DB becomes inconsistent after DB change command is entered during CAT2 OAM to SCCP Sync | |
| 36647339 | N | 3 | R47.0.0.1_CAT2: Server backup fails when CAT2 files are getting transferred from CAT2 Utility to EAGLE | Severity 1 "ftp_dos.c Line 714" observed
|
|
| 37229910 | Y | 3 | Customer receiving severity 1 trouble after lab upgrade to 47.1.0.1.0-79.34.0 | No customer impact. |
| 37490194 | Y | 3 | Protocol stats updated in VxWorks 6.9 | There is no operational impact to customer |
| 37538537 | N | 3 | Update upgrade guide to mention about cards that failed to flash during upgrade | |
| 37570934 | Y | 3 | SM8G flash issue occurs when card is present on IMT with BLMCAP flash and we are unable to flash the card to BLDC64 | When customer's STPs are operating on release 47.x and a failed system E5-SM8G-B card is replaced with the onsite spare that is flashed with BLMCAP GPL and not the required BLDC64 GPL, the card cannot be flashed, a command rejection error will be seen as below. > init-flash:loc=4111:code=appr:gpl=bldc64 E2212 Cmd Rej: Invalid card type for this command The card that is specified cannot be used with this command. The card will have to be sent in for an RMA to have the BLDC64 GPL preloaded on the replacement E5-SM8G-B card.
|
| 37595763 | Y | 3 | Inconsistent CDPA GTTSET selection for XUDT messages | No operational impact as issue seen only when using internal tst-msg commands.
|
| 37773080 | N | 3 | Update Procedure 10: Upgrading Removable medias and Procedure 11: Backing Up Fixed Disk | |
| 37797831 | Y | 3 | inconsistency reported under commands rept-stat-trbl V/s Rept-stat-card |
No impact to customer. |
| 38041236 | Y | 3 | R47.1.0.2MR: Observing Severity 1 "Module ath_ipscp.c Line 1901 Class 01b1" on GTT enabled IPSG card
|
No impact to customer. |
| 38053626 | N | 3 | R47.1.0.2MR: Links toggling continuously when original message packet size is larger than MTU size | No impact to customer. |
| 38146160 | Y | 3 | DEIR SLIC card shows UNKNOWN status on EPAP release 17.0.0 and 16.3.0 and Eagle release 47.1.0.1 | No Service Impact. EPAP reports SLIC DEIR card with status as UNKNOWN since EAGLE is sending DEIR cards in the EPAP card list even though SLIC DEIR does not directly connect to EPAPs. |
| 26257720 | N | 4 | Remove Stop Action value as "COPY" from chg/rtrv-gws-actset |
|
| 32292968 | N | 4 | In Vxworks6.9, maximum 1000 TPS per link is getting copied on IMF server in STC mode | |
| 34193254 | N | 4 | Retrieving data. Wait a few seconds and try to cut or copy again | |
| 34307478 | Y | 4 | R47.0_ST:Module ath_ipscp.c Line 1901 Class 01b1 Severity 1 observed on GTT enabled IPSG cards
|
Severity 1 ath_ipscp.c is observed when IPSG+GTT card is rebooted. No traffic/system Impact.
|
| 34527242 | N | 4 | rept-stat-iptps is showing incorrect output for IPSG69 ENETB card and SLIC card
|
|
| 34920961 | N | 4 | Add support for SLIC Version 3 | |
| 35853925 | Y | 4 | Bypass isolated cards in upgrade health check and don't mark them as obsolete | With isolated card(s) in the system, upgrade health check for those card location(s) may mark them as obsolete card(s), as isolated card(s) defaults to older GPLs (some of them are obsolete). This impacts the upgrade as until a Network card is placed in that location, upgrade doesn't proceed. |
| 35876884 | N | 4 | Automatic File Transfer of Security/Audit Logs | |
| 36164730 | N | 4 | SEAS - SSH client support in VxWorks69 | |
| 37522623 | N | 4 | Update CGBU_018327 document: SLIC SCCP supports 13.6K TPS with EPAP240M and EGMS features enabled | |
| 37986641 | Y | 4 | Increase Eagle FTP Server password strings to at least 16 characters. | Passwords with a small number of characters may be easier to guess. |
| 38166196 | N | 4 | Rel 47.1.0.2.0-79.38.0 : CMT update for using Flash-Card to flash SM8G cards from BLMCAP to BLDC64 | |
| 38188051 | N | 4 | EAGLE 47.1| VxWorks6.9| Ping Command with -f option not working as expected | Ping command with "-f" (Don't fragment) option does not set the Don't fragment bit in the IP layer flag and hence it cannot be used to identify the PMTU of the IP network. |
| 38568918 | N | 4 | Update EEDB to use TPD 8.10.1.7.0_150.18.0 |