Review and Block/Unblock Locally Connected Devices

Wired and wireless devices will connect to the Cloud Connector LAN either using a LAN Ethernet interface or one of the two wireless interfaces. Other than wireless authentication, the Devices tab lets you block and unblock these devices based on their MAC addresses.

1. Click the Devices tab at the bottom of the page.
2. Observe the list of connected devices and their attributes.

   MAC	MAC address of the device
   IP Address	IP Address of the device
   Status	Device status of: Connected: The device is actively connected to the Cloud Connector’s Wi-Fi network. Blocked: The device has been manually blocked by the user and cannot connect to the Wi-Fi network. Disconnected: The device is no longer connected to the local network.
   Connection	Which radio this device is connected to
   Last Activity	Last time the device and this Cloud Connector exchanged packets
   Last Wi-Fi Speed	Last upload and download speeds from the device.

3. Select one or more devices by checking the checkbox next to their MAC addresses.
4. Click Block available in the UI. A toast message may appear to confirm the block action. Click Confirm if prompted.

   Note:

   Blocking a device triggers a Wi-Fi restart on the Cloud Connector. This means that the Wi-Fi interface on this cloud connector will restart causing all devices, blocked ones included, to reconnect.
5. Manually refresh the page or switch Cloud Connector tabs to see the updated list.
6. Reselect one or more blocked devices by checking the checkbox next to their MAC addresses.
7. Click Unblock to allow that device to communicate through this Cloud Connector on the LAN.
8. Manually refresh the page or switch Cloud Connector tabs to see the updated list.