3.2.1 Procedure 1 SETTING UP UPGRADE ENVIRONMENT

Table 3-5 Procedure 1 SETTING UP UPGRADE ENVIRONMENT

STEP # A B This procedure sets up the Full upgrade environment. Estimated time: 5 minutes

1.

☐

☐

MPS X: Ensure that all the console/PuTTY Sessions are logged in a text file.

On all the console/PuTTY sessions, make sure that the logging in enabled and logs are written to a file.

For example, on a PuTTY session, follow the below steps:

  1. Right click the top bar in the PuTTY and select “Change Setting”.

  2. Click on “Logging”.

  3. Select “Printable output”.

  4. Click “Browse” and choose where you want the logs to be written to collect those logs later, when needed. Assign a name which will be easy to identify later.

    For example, name of the log file can be.

    <Server name>_active_pdba_A_server_puttylog_ddmmyyyy.

  5. Click “Save”.

  6. Type “Putty Logging starts” in the PuTTY session and check whether the text is logged in the PuTTY log file.

    Repeat the above six steps on every console/PuTTY session that will be used to enter commands or run a procedure in this document.

2.

☐

☐

MPS X:

Login as root to MPS 

SSH to MPS IP: 
login: root 
password: <root_password>

3.

☐

☐

MPS X:

Start capture file.

Start a capture file using IsoConsole, or by starting a local screen session and capturing its output.

4.

☐

☐

MPS X: Access mate MPS via serial console

# minicom mate

5.

☐

☐

mate MPS: Login as root.

Console login: root

password: <root_password>

This procedure is complete!