bfd-config > bfd-session
The bfd-session configuration element is used for configuring individual BFD sessions.
Parameters
- bfd-sess-type
- Specifies the type for this specific session.
- Default: primary
- Values: vip/primary/secondary
- admin-state
- Specifies whether this specific session is enabled.
- Default: disabled
- Values: enabled/disabled
- admin-session-state
- Allows you to put this specific session in admin-down state.
- Default: adminDown
- Values: up/adminDown
- min-tx-interval
- Specifies the min-tx-interval in milleseconds. Refer to RFC 5880
for more details.
- Default: 50
- Values: 1-65535
- min-rx-interval
- Specifies the min-rx-interval in milleseconds. Refer to RFC 5880
for more details.
- Default: 50
- Values: 1-65535
- detect-multiplier
- Specifies the detect-multipler as an integer. Refer to RFC 5880
for more details.
- Default: 3
- Values: 1-255
- hold-down-time
- Specifies the hold-down-time in milleseconds. Zero is disabled.
- local-discriminator
- Specifies the integer used by the system to identify this
session. Values range from 1 - 4294967295.
- Default: 3
- Values: 1-4294967295
Path
bfd-session is an element under the network-interface path. The full path from the topmost prompt is: