1. ACLI Reference Guide
  2. ACLI Configuration Elements A-M
  3. capture-receiver

capture-receiver

The capture-receiver configuration element allows you to specify a target for packet mirroring from the Oracle Communications Session Border Controller to that target. This command is only applicable to packet-trace remote.

Parameters

state
Enable or disable the Oracle Communications Session Border Controller’s TRACE capability.
  • Default: disabled
  • Values: enabled | disabled
Disable capture receivers you are not actively using for traces to prevent potential service outages caused by the capture's system resource utilization.
address
Enter the TRACE server IP address.
network-interface
Enter the TRACE server outbound interface. The argument accepts the full interface name, including the sub-port-id. The command assumes sub-port-id 0 if it is not specified.

Path

capture-receiverIs an element of the system path. The full path from the topmost ACLI prompt is: configure terminal > system > capture-receiver.