1. Setup Guide
  2. Workstation Setup
  3. Installing the Biometric Fingerprint Module

Installing the Biometric Fingerprint Module

The Compact Workstation 310 supports an optional biometric fingerprint module. The hex key is required for installation.
Note: Power off the workstation before installing the fingerprint module.
  1. Place the workstation face down on flat surface, and then use the hex key to remove the screw from the dummy cover. Lift the cover out of the slot.

    Figure 3-18 Removing the Dummy Cover

    This image depicts the hex key removing the screw from the dummy cover, located on the back of the workstation.
  2. Drop the fingerprint module into the open slot.

    Figure 3-19 Installing the Fingerprint Module

    This image shows installation of the fingerprint module into the slot on the back of the workstation.
  3. Use the hex key to secure the fingerprint module.

Parent topic: Workstation Setup