Mounting the Compact Workstation 3 Series on the Flexible Stand
Mounting the Compact Workstation 3 Series on the Flexible Stand
Remove the I/O panel cover by sliding it off the workstation.
Figure 3-1 Removing the Workstation I/O Panel Cover
Place the Flexible Stand upright on a flat surface. Note
the location of the four mounting tabs and the quick release pin,
as shown in the following image.
Figure 3-2 The Flexible Stand Workstation Mounting Tabs
Place the workstation on the stand by inserting the four
mounting nubs into the mounting tabs on the stand.
Figure 3-3 Mounting the Compact Workstation 3 Series on the Flexible Stand
Pull the workstation toward you until you hear the quick
release pin click. If it is not depressed, you must pull the workstation
toward you until it clicks in place.
Figure 3-4 Location of the Compact Workstation 3 Series Security Screw
For added stability and security, install the security
screw.