1. Setup Guide
  2. Workstation Setup
  3. Mounting the Compact Workstation 3 Series on the Basic Stand

Mounting the Compact Workstation 3 Series on the Basic Stand

  1. Place the Basic Stand upright on a flat surface.
  2. Remove the workstation I/O panel cover.

    Figure 3-5 Removing the Compact Workstation 3 Series I/O Panel Cover

    This image depicts removing the IO panel cover from the workstation.
  3. Place the flat side of the Basic Stand on the workstation by aligning the open slots over the four workstation mounting nubs.
  4. Slide the Basic Stand up to join the stand with the workstation.

    Figure 3-6 Attaching the Compact Workstation 3 Series to the Basic Stand

    This image depicts sliding the Basic Stand up to join it with the workstation.
  5. Secure the stand to the workstation using the provided security screw and hex wrench.

    Figure 3-7 Attaching the Compact Workstation 3 Series to the Basic Stand

    This image shows the installation of the security screw.
  6. Connect the required cables, and then re-attach the I/O panel cover.

Parent topic: Workstation Setup