Securing the Flexible Stand to a Counter
The Flexible Stand is a mounting option for the Compact Workstation 310. When using this option, ensure that the stand is properly secured to a counter.
Note: The mounting screws are not provided. Ensure that you are using screws that meet the needs of the installation. The stand mounting hole diameter is ~4.9mm (0.193” = ~3/16”) and will accept up to a #10 or M4 screw. The screw length should be a minimum of one inch plus the thickness of the counter.
Note: If using a battery power option in conjunction with your workstation, you must first attach the battery enclosure to the stand before securing the stand to the counter.
Note: Connect and route all required cables before securing the stand to the counter.
- Download the Oracle MICROS Flexible Stand Mounting Template and print it on legal size (8.5 x 14) paper. To ensure the template is properly printed, place a stand on the template and see if holes are aligned.
- Place template on the counter surface. If multiple units will be installed on a counter surface, ensure all units are mounted at the proper distance from the edge of the counter.
- Mark the four screw locations on the counter. If available, use a small punch tool to create small pilot hole (indentation).
- Remove template, and then drill the holes.
- Recommended metal surface hole diameter: 7/32" (5.5mm) drill bit size 7/32" (5.5mm).
- Recommended wood surface hole diameter: 15/64" (6mm) drill bit size 15/64" (6mm).
- Install screws in the two counter holes that correspond with the back (logo side) of the stand. Leave at least .25 inches of each screw above the counter surface.
- Place the Flexible Stand on the counter surface so that the two back screw grooves align with the screws installed on the counter.
- Slide the stand until the screw holes on the front of the stand align with the holes in the counter surface.
- Install/tighten all screws.
Parent topic: Workstation Setup