Set Up the Populate Data Attributes
You may control data population based on data attributes.
The following is the list of profile switch along with their value required to be set to populate data attributes.
Table 8-1 Populate Data Attribute-Value set
Attribute | Value |
---|---|
POPULATE AFFILIATE DATA |
0 — Do not bring any affiliate data into the Oracle Argus Insight data mart. 1 — Bring all affiliate data into the Oracle Argus Insight data mart. |
POPULATE INTERCHANGE DATA |
0 — Do not bring any interchange data into the Oracle Argus Insight data mart. 1 — Bring all interchange data into the Oracle Argus Insight data mart. 2 — Bring only the SAFETYREPORT, MESSAGES, and EDI_INFO tables data into the Oracle Argus Insight data mart. |
POPULATE CASE/CONFIGURATION DATA |
0 — Populate configuration data only. 1 — Populate all the data (both case and configuration data). |
LEGACY REPORTS CONFIGURATION |
0 — Configuration items are not visible. 1 — Configuration items are visible. Note: If Legacy Reports Configuration switch is set to 1, then legacy reports switches becomes available for obsolete reports, and you must configure the following switches:
To configure these switches, refer to Oracle Argus Insight Installation Guide (v7.02). |
To set the data attributes: