Auto-refresh

• If selected—The page refreshes automatically at the interval specified on the Settings tab of the My CIS page.
• If not selected—The page does not refresh automatically.

Create New Sync Connection

Click to display the first page of the CIS Synchronization Connection Wizard and start to create a new synchronization connection.

Status (filter)

List of possible synchronization connection statuses. To display only synchronization connections in a specific status, select the status from the drop-down list. Possible status filters are:

• All
• Complete
• Running
• Fault

The columns of the synchronization connection table display information about each synchronization connection.

CIS Sync Name

Name of the synchronization. This is the name entered when the synchronization connection was created.

Last Sync Start (UTC)

Last time the synchronization started. Synchronization schedule time is stored as Universal Coordinated Time (UTC) time.

Last Sync Duration (min)

Number of minutes and seconds it took to complete the synchronization.

Next Sync Start

Next time the synchronization is scheduled to start. Synchronization schedule time is stored as Universal Coordinated Time (UTC) time.

Enabled state

• Yes—The synchronization is enabled. The synchronization runs using the schedule you define.
• No—The synchronization is disabled.

Note: If a synchronization is disabled, you can start the synchronization manually by clicking Sync Now.

Status (synchronization connection)

Run status of the synchronization. A synchronization can have the following status:

• Green Square—Indicates that the last synchronization was successful and all transactions for that synchronization were sent to both the InForm software and the Clintrial software. However, this column only displays the status for the last synchronization and does not indicate that all transactions have been synchronized. If additional transactions were generated by the InForm software or the Clintrial software, these transactions do not appear until the next synchronization completes.
• Orange Diamond—Indicates the synchronization is still running.
• Red Triangle—Indicates an error has occurred.