View Single Sensor Details

Follow this step to view details of a single sensor on a managed device.

1. To view details about a single sensor on a managed device, type:

   sensor get /target/sensor_name

   For example, to view sensor details about the system temperature (/SYS/T_AMB), you would type:

   $ ipmitool -I [orcltls|lanplus] -H SP_hostname_or_IPaddress -U
                                 username
                                  -P
                                 password
                             

   
                                 sensor get /SYS/T_AMB
                             

   Note:

   The IPMI TLS interface (orcltls) is supported as of Oracle ILOM firmware version 3.2.8 and later. For a higher level of security, you should always specify the IPMI TLS interface (-I orcltls) when executing Oracle ILOM commands from the IMPItool utility. For more information about using the IPMI TLS interface from Oracle, see these topics:IPMI TLS Service and Interface and Configure IPMI Management Access for Increased Security in Oracle ILOM Security Guide For Firmware Release 5.1.x

   The output might look like the following:

   Locating sensor record...
   Sensor ID              : /SYS/T_AMB (0x8)
    Entity ID             : 41.0
    Sensor Type (Analog)  : Temperature
    Sensor Reading        : 24 (+/- 0) degrees C
    Status                : ok
    Lower Non-Recoverable : 0.000
    Lower Critical        : 4.000
    Lower Non-Critical    : 10.000
    Upper Non-Critical    : 35.000
    Upper Critical        : 40.000
    Upper Non-Recoverable : 45.000
    Assertions Enabled    : lnc- lcr- lnr- unc+ ucr+ unr+
    Deassertions Enabled  : lnc- lcr- lnr- unc+ ucr+ unr+