Use a lift to raise the server to its position in the rack.
Caution:
Personal injury or equipment damage: Always load equipment into a rack
from the bottom up so that the rack does not become top-heavy and tip over.
Deploy your rack anti-tip device to prevent the rack from tipping during
equipment installation.
Caution:
Personal injury or equipment damage: Be sure the server is firmly
supported by the shelf rails before releasing it from the lift.
Slowly slide the server into position on the shelf rails.
Do not remove support from the lift until the server is fully supported by
the shelf rails.
Using a No. 2 Phillips screwdriver, use eight M6 screws to attach the
front of the server to the rack.
The top two screws attach to the cage nuts installed previously. The
bottom screws attach to threaded holes in the shelf rails.
Press the back mounting brackets against the server and tighten the
screws.