Remove the Front LED Indicator Module

1. Prepare the server for service.
   1. Power off the server and disconnect the power cords from the power supplies.

      See Powering Down the Server.

   2. Remove the server from the rack.

      See Remove the Server From the Rack.

   3. Attach an antistatic wrist strap to your wrist, and then to a metal area on the chassis.

      See Take Antistatic Measures.

2. Remove the left-side mounting bracket from the server chassis.
   
   
   
   1. Lift up on the mounting bracket clip to disengage the clip from the chassis locating pin.
   2. Pull the mounting bracket toward the rear of the chassis until all five chassis locating pins protrude through the five keyhole openings in the mounting bracket.
   3. Lift the mounting bracket off the locating pins and set it aside.
3. Using a Philips screwdriver, remove the two screws that secure the front indicator module (FIM) assembly to the server chassis [1].
   
   
   
4. Carefully slide the FIM assembly toward the front of the server to remove it from the chassis [2].
5. Using a Phillips screwdriver, remove the two screws that secure the plastic temperature sensor housing to the FIM assembly, and then detach the housing from the FIM assembly [2].

   Note:

   You do not need to remove the temperature sensor from the housing.
6. Disconnect the FIM cable from the FIM assembly and set the FIM assembly aside [3].
7. Continue to Install the Front LED Indicator Module.