20 Returning the Server to Operation
After replacing components inside of the server, perform the procedures in the following sections:
Server Filler Panel Requirements
The server might be shipped with module-replacement filler panels for storage drives and PCIe cards. These filler panels are installed at the factory and must remain in the server until you replace them with a purchased option.
Before you can install an optional server component into the server, you must remove the filler panel from the location into which you intend to install the component. When you remove a storage drive or a PCIe card from the server, you must install either a replacement for the component removed or a filler panel.
Remove Antistatic Measures
- Remove any antistatic straps or conductors from the server chassis. removing components antistatic measures
Reinstall the Server Into the Rack
After servicing the system, reinstall it into the rack.
Caution:
Deploy any rack anti-tilt mechanisms before installing the server into the rack.Caution:
The server weighs approximately 35.0 lbs (15.88 kg). Two people are required to carry the chassis and install it into the rack.Return the Server to the Normal Rack Position
If the server is in the extended maintenance position, use this procedure to return the server to the normal rack position.
Power On the Server
As soon as the power cords are connected, Standby power is applied. In Standby power mode:
-
The System OK LED on the server front panel blinks slowly.
-
The SP OK LED indicator is steady on.
-
The AC power supply LED indicator lights are steady on.
Depending on the firmware configuration, the system might boot. If it does not boot, perform the following procedure.
-
Power on the server to Main power mode by performing one of the following
actions:
-
Press the On/Standby button on the front bezel.
-
Log in to the Oracle ILOM web interface, click Host Management → Power Control, and select Power On from the Select Action list.
-
Log in to the Oracle ILOM command-line interface (CLI), and type the following command at the Oracle ILOM prompt:
->
start /SystemWhen the server is powered on to Main power mode and the power-on self-test (POST) code checkpoint tests are complete, the green System OK LED status indicator on the front panel of the server lights and remains lit.
-