1. Installation and Configuration Guide
  2. Configure the Library Connection (SNMP or SCI)
  3. Troubleshoot the Library Connection
  4. Enable and Test the SCI Destination on the SL4000

Enable and Test the SCI Destination on the SL4000

Verify the SCI destination is enabled and run a test to validate the configuration to the STA server is properly defined. The test sends a "test" event message to the destination.

Access the SL4000 GUI Notifications Page

  1. Log into the SL4000 GUI.
  2. Click Notifications in the left navigation area.
  3. Click the SCI tab.

Verify the Destination is Enabled

  1. Verify the Enabled column for the STA destination says Yes.


    Sample Notifications table with Enabled column noted.

  2. If not, select the STA destination in the table and then click Edit Edit SCI Destination icon.
  3. Check the Enabled box, and then click Ok.

Test the Destination

  1. Select the STA destination in the table.
  2. Click Test Test SCI destination icon, and then confirm the test.
  3. If the test fails, you may need to manually configure the destination. See Manually Configure the SL4000 to Send Outbound SCI to STA.