Configure Time Settings

Set the library date and time using the configuration wizard.

1. This procedure assumes you have started the configuration wizard and selected Configure Time Settings.

   If not, see Launch the Configuration Wizard.

2. You must restart the library after making changes to the time settings. Do not proceed unless you can restart the library now.
3. Select the Op Panel Time Zone. You should use the time zone where the library is physically located.

   Internally the library always runs on UTC (coordinated universal time), but the library uses the "Op Panel Time Zone" parameter to adjust the times displayed at the local operator panel. For browser connections, the GUI automatically adjusts the time to the local time of the browser.

4. Select an option for Configure Date and Time:
   • Using Network Time Protocol — Enter the address of up to five Network Time Protocol (NTP) servers.
   • Manually — Enter the time using the same time zone as the library time zone. The library will adjust its internal clock to UTC based on the library time zone parameter selected above.
5. Accept the changes and allow the library to restart.