Configure Network Settings (Public, Service, and OKM Ports)

Each network port has its own configuration step in the configuration wizard.

1. This procedure assumes you have started the configuration wizard and selected Configure Network Settings.

   If not, see Launch the Configuration Wizard.

2. Enter applicable IPv4 or IPv6 information for each port you want to configure.

   Note:

   Each port must be on a separate subnet. If network ports are on the same subnet, you will only be able to reach one port.

   You must proceed through each port one screen at a time. For example, to configure only the OKM port, click Next to bypass the public and service port pages. There is no way to start at the OKM port page.

   • Public Network Port (Customer Port) — IP information is required. DNS information is optional, but all DNS information must be valid before applying the configuration. Incorrect DNS information or unreachable DNS servers, will cause the library startup to take up to 2 hours.

     Caution:

     If using DNS, verify all DNS server information is correct and that the Customer Port has a valid link before applying the configuration. Invalid DNS information can cause library startup to take 2 hours.
   • Service Network Port — IP address and netmask information is required. Gateway information is optional. You can accept the default information.
   • Oracle Key Manager Port — IP information is optional. You can select Port Disabled, which will unconfigure and take down the port.