Install Power Supplies and Tape Drives

Power supplies and tape drives install into the rear of each module.

Note:

If you are not installing additional drives or power supplies, skip to Cable the Library.

• Remove the Power Supply Slot Cover
• Insert a Power Supply into the Slot
• Remove the Drive Slot Cover
• Insert a Tape Drive Tray into the Slot

You can add power supplies and tape drives while the library is powered-on. However, you must restart the library for it to recognize the tape drives if the library is not set to address all drive slots.

Figure 2-23 SL150 Library Rear View

Illustration Legend:

1 - Tape Drive Filler

2 - Power Supply Filler

Figure 2-24 Power Supply

Illustration Legend:

• 1 - Power Supply Indicators
• 2 - Power Supply Latch

Figure 2-25 Tape Drive Tray

Illustration Legend:

• 1 - Drive Indicators
• 2 - Port Indicators (HP drives only)
• 3 - Encryption Indicators
• 4 - Thumbscrew (One on Each Side of the Tray)