Create a WTC Queuing Bridge Redirection
Configuration Options Related Tasks Related Topics
Use this page to create a new WTC queuing bridge redirection.
Name Description Name
The name of this redirection.
The direction of data flow. At least one redirection must be specified or the Tuxedo queuing bridge will fail to start and an error will be logged.
Each defined direction is handled by starting a new thread.
- From JMS to TUXEDO /Q
- From TUXEDO /Q to JMS
- From JMS to TUXEDO Service reply to JMS
- From JMS to JMS
The type of XML/FML translation.
NOindicates that no data translation is performed.
FLATindicates that the message payload is transformed using the WebLogic Tuxedo Connector translator.
WLXTindicates that translation is performed by the XML-to-non-XML WebLogic XML Translator (WLXT).
Note: WLXT is not supported for this release.
The name of the JMS queue used specifically for synchronous calls to a Tuxedo service. The response is returned to the JMS ReplyQ.
Source Access Point
The name of the local or remote access point where the source is located.
The name of the Qspace for a source location.
The name of a source queue or service. Specifies a JMS queue name, a Tuxedo queue name, or the name of a Tuxedo service.
Target Access Point
The name of the local or remote access point where the target is located.
The name of the Qspace for a target location.
The name of the target queue or service. Specifies a JMS queue name, a Tuxedo queue name, or the name of a Tuxedo service.