This chapter describes the tasks you may have to complete after installing Oracle Communications Services Gatekeeper and configuring the WebLogic Server domain for use with it. These include
You may not need to do all of the following tasks depending on the type of installation with which you are working.
If you have added any Network Tier servers to the initial two provided by the domain template, you must edit the configuration to add support for the EDR Service. Each server in the Network Tier requires its own JMS server in order for the EDR Service to work correctly.
For the following task, you must start the Administrative Server in your Oracle Communications Services Gatekeeper installation so that you can use the Management Console to make the necessary adjustments. Unless you are setting up an all in one domain, you will also need to start at least one Network Tier server (this prevents a null pointer error in initializing the Console). For more information on using the Console, please see the System Administration Guide, a separate document in this set. The following is an overview only:
|Note:||You can also log into the NT server, and run the
In your browser, enter the following address:
http://<hostname>:<port>/console, where <hostname> is the Administrative Server and port is the ListenAddress assigned during Domain Configuration. The default value is 7001.
If this is the first time you have logged in, you should use username:
weblogic. There are instructions in the System Administration Guide on changing these values once your system is fully configured.
Lock & Editin the
Change Centeron the left side of the window.
(In the example below, assume that the additional server WLNG_NT3 was created.)
In the Management Console:
Oracle Communications Services Gatekeeper does not require the JCE files, but you can install them if you wish to use JCE providers. For more information, please see the section about the nCipher JCE Provider in Oracle WebLogic Server Securing WebLogic Server at http://download.oracle.com/docs/cd/E12840_01/wls/docs103/secmanage/.
If your installation is using the SOA Facade with Oracle Service Bus, you will need to take a number of steps to integrate Oracle Communications Services Gatekeeper with Oracle Service Bus. See Installation of SOA Facades for more information.
Using features available through Oracle. WebLogic Server 10.3, you can create and configure a Password Validation Provider. This will allow you to enforce rules concerning the composition of passwords used with Oracle Communications Services Gatekeeper. In general, the rules include:
For more information, see “Configuring Authentication Providers” in Securing WebLogic Server, atYou will need to use WLST to create and configure your Password Validation Provider.
Once you have installed the software, configured the domain, and completed any necessary post-installation steps, you can proceed to configuring Oracle Communications Services Gatekeeper itself. The specifics for doing these tasks are presented in the System Administrator’s Guide and Managing Accounts and SLAs, but the following list gives you a general outline of the initial tasks you must perform:
To learn more about installing WebLogic Server products in general, and about the installer program in particular in regard to WebLogic Server, see the WLS.