1. Overview of the Oracle VM Server for SPARC Software
2. Installing and Enabling Software
4. Setting Up Services and the Control Domain
Introduction to a Virtual Network
Set Options for an Existing Virtual Switch
Managing a Virtual Network Device
Set Options for an Existing Virtual Network Device
Remove a Virtual Network Device
Virtual Device Identifier and Network Interface Name
Find Oracle Solaris OS Network Interface Name
Assigning MAC Addresses Automatically or Manually
Range of MAC Addresses Assigned to Logical Domains
Automatic Assignment Algorithm
Duplicate MAC Address Detection
Using Network Adapters With Logical Domains
Determine If a Network Adapter Is GLDv3-Compliant
Configuring Virtual Switch and Service Domain for NAT and Routing
Set Up the Virtual Switch to Provide External Connectivity to Domains
Configuring IPMP in a Logical Domains Environment
Configuring Virtual Network Devices Into an IPMP Group in a Domain
Configuring and Using IPMP in the Service Domain
Using Link-Based IPMP in Logical Domains Virtual Networking
Configure Physical Link Status Updates
Configuring and Using IPMP in Releases Prior to Logical Domains 1.3
Configuring IPMP in the Guest Domain
Configuring IPMP in the Service Domain
Assign VLANs to a Virtual Switch and Virtual Network Device
Install a Guest Domain When the Install Server Is in a VLAN
Configure a Virtual Switch With an NIU Network Device
Using Link Aggregation With a Virtual Switch
Configure Virtual Network and Virtual Switch Devices to Use Jumbo Frames
Compatibility With Older (Jumbo-Unaware) Versions of the vnet and vsw Drivers
12. Performing Other Administration Tasks
A. Oracle VM Server for SPARC Physical-to-Virtual Conversion Tool
B. Oracle VM Server for SPARC Configuration Assistant
C. Logical Domains Manager Discovery
D. Using the XML Interface With the Logical Domains Manager
A virtual switch (vsw) is a component running in a service domain and managed by the virtual switch driver. A virtual switch can be connected to some guest domains to enable network communications between those domains. In addition, if the virtual switch is associated also with a physical network interface, then this allows network communications between guest domains and the physical network over the physical network interface. A virtual switch also has a network interface, vswn, which allows the service domain to communicate with the other domains connected to that virtual switch. It can be used like any regular network interface and configured with the ifconfig(1M) command.
Note - When a virtual switch is added to a service domain, its network interface is not plumbed. So, by default, the service domain is unable to communicate with the guest domains connected to its virtual switch. To enable network communications between guest domains and the service domain, the network interface of the associated virtual switch must be plumbed and configured in the service domain. See Enabling Networking Between the Control/Service Domain and Other Domains for instructions.