Capturing Configuration Variable Settings

While the Solaris operating environment is still running, capture the NVRAM configuration variable settings before you install the Solaris 7 operating environment or begin the flash PROM update process. This will enable you to restore customized settings if there is a problem during the flash PROM upgrade.

To Capture the Configuration Variable Settings

1. Using the eeprom utility, capture the system's configuration variable settings in a file. The filename is any file name you choose.

   ---

   % eeprom > filename
   

   ---

   ---

   Note -

   If you have custom values installed in oem-logo or keymap, those values cannot be displayed or printed properly by the eeprom utility because the contents contain binary information. If it is necessary to restore these values after a power loss, you should determine the original method by which these values were placed into NVRAM and use that method to restore the values.

   ---

2. Print out the values captured by the eeprom command. You must have a printed copy of the configuration values before you install the Solaris 7 operating environment and begin to update the flash PROM. Type the following:

   ---

   lp filename 
   

   ---

To Install the Solaris 7 Operating Environment

1. Install the Solaris 7 operating environment on your system.

   Refer to the Installation Library shipped in your Solaris 7 media kit. As the Solaris 7 operating environment is installed, you will be notified whether the flash PROM in your system needs updating. Installing this Solaris release will provide the software that can upgrade your system's flash PROM to the required level.