Remote Management > Administering ILOM (CLI) > Controlling ILOM Targets (CLI) > Managing SNMP Services (CLI) |
Documentation, Support, and Training
Understanding ILOM on the Switch
Switching Between the ILOM Shell and the Linux Shell
Switch From the ILOM Shell to the Linux Shell
Switch From the Linux Shell to the ILOM Shell
Display the Date, Time, and Time Zone (CLI)
Display the Aggregate Sensor State (CLI)
Display the ILOM Sessions (CLI)
Display the ILOM Event Log (CLI)
Checking the Status of Services (CLI)
Display the HTTP Service Status (CLI)
Display the HTTPS Service Status (CLI)
Display the SSL Certificates (CLI)
Display the SNMP Service Status (CLI)
Display the SNMP Service User Accounts (CLI)
Display the SNMP Service Communities (CLI)
Display the IPMI Service Status (CLI)
Get Help on an ILOM Command (CLI)
Get Help on an ILOM Target Property (CLI)
Display the Alert Properties (CLI)
Display the ILOM User Accounts (CLI)
Display the Remote Log Hosts (CLI)
Display the Network Management Configuration (CLI)
Display the ILOM CLI Session Timeout (CLI)
Display Chassis FRU ID Information (CLI)
Display the ILOM Firmware Version (CLI)
Controlling ILOM Targets (CLI)
Performing General Tasks on ILOM Targets (CLI)
Set the Date, Time, and Time Zone (CLI)
Clear the ILOM Event Log (CLI)
Set the Remote Log Hosts (CLI)
Back Up the ILOM Configuration (CLI)
Restore the ILOM Configuration (CLI)
Set the Network Management Parameters (CLI)
Performing ILOM User Tasks (CLI)
Add an ILOM User Account (CLI)
Change an ILOM User's Password and or Role (CLI)
Delete an ILOM User Account (CLI)
Disable the HTTP Service (CLI)
Enable the HTTPS Service (CLI)
Install a Custom SSL Certificate (CLI)
Remove the Custom SSL Certificate (CLI)
Disable the HTTPS Service (CLI)
Add SNMP Service User Accounts (CLI)
Modify SNMP Service User Accounts (CLI)
Delete SNMP Service User Accounts (CLI)
Add SNMP Service Communities (CLI)
Modify SNMP Service Communities (CLI)
Delete SNMP Service Communities (CLI)
Back Up SNMP Service MIBs (CLI)
Disable the SNMP Service (CLI)
Enable Alerts to Send SNMP Traps (CLI)
Enable Alerts to Send PET (CLI)
Set the ILOM CLI Session Timeout (CLI)
Upgrading the Switch Firmware Through ILOM (CLI)
Install the flint Application (CLI)
Download the Switch Firmware Package (CLI)
Set Component Firmware to Upgrade (CLI)
Upgrade the Switch Firmware (CLI)
Access the ILOM CLI.
Configure the SNMP parameters:
-> set /SP/services/snmp property=value property=value ...
where:
property is the parameter of the network to configure.
value is the value of the property to configure
The following properties are supported:
port – The value is the UDP port for SNMP.
servicestate – The value is either enabled or disabled.
sets – The value is either enabled or disabled for set requests.
v1 – The value is either enabled or disabled for this protocol.
v2c – The value is either enabled or disabled for this protocol.
v3 – The value is either enabled or disabled for this protocol.
Note - You can configure one to all properties in one command line.
For example, to enable sets and the v2c protocol:
-> set /SP/services/snmp sets=enabled v2c=enabled Set ’sets’ to ’enabled’ Set ’v2c’ to ’enabled’ ->