Skip Navigation Links | |
Exit Print View | |
Sun Server X2-8 (formerly Sun Fire X4800 M2) Service Manual Sun Server X2-8 (formerly Sun Fire X4800 M2) Documentation Library |
Sun Server X2-8 Service Manual Overview
Controlling Server Power Remotely
Removing and Installing Components
Preparing for Service and Operation
Removal and Installation Procedures
Removing and Installing a Power Supply (CRU)
How to Remove and Install AC Power Cables
Removing and Installing a Hard Drive (CRU)
Removing and Installing a Hard Drive Filler
Replacing the Hard Drive Backplane (FRU)
Adding, Removing, and Installing a CMOD (CRU)
CPU Module (CMOD) Designation and Population Rules
Removing and Installing a CMOD Filler
How to Replace the CMOD Battery (CRU)
Removing and Installing DIMMs (CRU)
Removing and Installing a RAID Expansion Module (CRU)
Removing and Installing a Fabric Expansion Module (CRU)
Replacing a CPU and Heatsink Assembly (FRU)
Removing and Installing a Fan Module (CRU)
Replacing a Fan Module Controller Board (FRU)
Removing and Installing a NEM or a NEM Filler (CRU)
Removing and Installing a PCIe EM (CRU)
Removing and Installing the Service Processor Module (CRU)
Removing and Installing the Multiport Cable
Removing and Installing the Subassembly Module (FRU)
Sun Server X2-8 Service Procedures and Information
Firmware Information and Procedures
How to Access the BIOS Setup Utility
Component LED Locations and Functions
Sun Server X2-8 Specifications
How to Request Physical Media Online
An animation of the procedure to install a power supply is available. See animation showing power supply installation.
Before You Begin
The handle should extend away from the power supply.
Correct positioning ensures that the connector on the power supply is aligned with the connector on the internal backplane of the server.
Note - In this position, the power supply is not flush with the face of the server, and the connectors on the power supply are not engaged with the connectors on the internal midplane. Do not attempt to force the power supply into the server any farther.
Caution - Pinch point. When operating the lever, keep your fingers clear of the back side of the lever and the lever hinges. |
This action draws the power supply into the slot and engages the connector on the power supply with the connectors on the internal backplane.
This action produces a click when the lock engages. In this position, the power supply cannot be slid out of the server unless the release handle is unlocked and lifted first.
Next Steps
See Also