Set Up PVID on a Port

1. Enter the configuration mode for the interface.

   TOR-1 SEFOS# configure terminal
   TOR-1 SEFOS(config)# interface  extreme-ethernet 0/1
   TOR-1 SEFOS(config-if)#

2. Set the PVID value.

   TOR-1 SEFOS(config-if)# switchport pvid 10
   TOR-1 SEFOS(config-if)# end
   TOR-1 SEFOS#

3. Display VLAN related parameters for port 0/1.

   TOR-1 SEFOS# show vlan port config port extreme-ethernet 0/1
    
   Vlan Port configuration table
   -------------------------------
   Port Ex0/1
    Port Vlan ID                     : 10
    Port Acceptable Frame Type       : Admit Only Untagged and Priority Tagged
    Port Ingress Filtering           : Disabled
    Port Mode                        : Access
    Port Gvrp Status                 : Disabled
    Port Gmrp Status                 : Enabled
    Port Gvrp Failed Registrations   : 0
    Gvrp last pdu origin                : 00:00:00:00:00:00
    Port Restricted Vlan Registration   : Disabled
    Port Restricted Group Registration  : Disabled
    Mac Based Support                   : Disabled
    Subnet Based Support                : Disabled
    Port-and-Protocol Based Support     : Enabled
    Default Priority                    : 0
    Filtering Utility Criteria          : Default
    Port Protected Status               : Disabled
    -------------------------------------------------------
    
   TOR-1 SEFOS#