Perform this procedure to transfer all operation of protection groups in a multigroup to partner clusters in the specified site.
Caution - To avoid possible loss of replicated data, use instead the geomg switchover command. The geomg takeover command is intended only for situations where the potential risk of data loss is justified, such as when the primary site is not available or during unplanned downtime. |
For more information about RBAC, see Securing Geographic Edition Software in Oracle Solaris Cluster Geographic Edition Installation and Configuration Guide .
# chmod A+user:username:rwx:allow /var/cluster/geo
The /var/cluster/geo directory must have the correct access control lists (ACL) applied for compatibility between the Geo Management RBAC rights profile and data replication software.
# geomg takeover [-f] -s site multigroup
Forces takeover, even if the primary cluster for a protection group in the multigroup is reachable and the protection group is active on that cluster.
The name of the standby site which is to take over the specified multigroup.
The name of the multigroup to take over.
See the geomg (1M) man page for information about additional options for the takeover subcommand.
Next Steps
For information about failing back a protection group to the original cluster, see Recovering a Protection Group to a Cluster.