Domain --> Configuration --> SNMP

Enabled

The state of the SNMP service on an administration server. Select to enable the service.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: Enabled

Default: false

Valid values:

• true

• false

SNMP Port

The port number on which the WebLogic SNMP agent listens for requests from SNMP managers.

Most SNMP managers can ping SNMP agents and some SNMP managers can request the status of specific attributes.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: SNMPPort

Minimum: 1

Maximum: 65535

Default: 161

MIB Data Refresh Interval

The minimum amount of time all MIB values are cached before the agent attempts to refresh them.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: MibDataRefreshInterval

Units: seconds

Minimum: 30

Maximum: 65535

Default: 120

Server Status Check Interval Factor

Defines a multiplier used to calculate the interval at which the server status is checked.

This value is multiplied by the MIB Data Refresh Interval to determine the interval at which server status is checked:

interval = n * MibDataRefreshInterval

The most frequent interval at which server status can be checked is the interval defined for MIB Data Refresh Interval. If you want that interval to be the same as the MIB Data Refresh Interval, enter 1 in the Server Status Check Interval Factor field.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: ServerStatusCheckIntervalFactor

Minimum: 1

Maximum: 65535

Default: 1

Community Prefix

The SNMP community (password) that SNMP managers must specify when sending requests to the WebLogic SNMP agent.

For more information about the community prefix, refer to "Using Community Names to Specify Target Servers in Management Requests."

The default value is public. However, to secure access to the values of the WebLogic attributes, it is recommended that you set Community Prefix to some value other than public.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: CommunityPrefix

Default: "public"

Debug Level

Determines whether internal messages are generated indicating what the agent code is doing.

The Debug level. Valid values are:

• 0-NoDebug messages

• 1-Fatal

• 2-Critical

• 3-Non-Critical

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: DebugLevel

Default: 0

Valid values:

• 0

• 1

• 2

• 3

Trap Version

Specifies whether this WebLogic Server domain generates traps that conform to SNMPv1 or SNMPv2.

Choose the protocol that your SNMP managers support.

Send Automatic Traps Enabled

Determines whether the WebLogic SNMP agent sends automatically generated traps to SNMP managers.

By default, the WebLogic SNMP agent sends traps when servers start and shutdown. For a complete list of events that generate automatic traps, refer to "Automatically Generated WebLogic SNMP Traps."

Targeted Trap Destinations

WebLogic Server uses a trap destination to specify the SNMP management station and the community name used by the SNMP agent to send trap notifications.

Select which trap destination(s) should be used in this WebLogic Server domain from the list of available trap destinations.

For information on creating Trap Destinations, refer to Creating a Trap Destination.

MBean: weblogic.management.
configuration.
SNMPAgentMBean

Attribute: TargetedTrapDestinations