What to Do

1. Connect the SSP data cable to the main logic board at connector J4201.

   1. Lift the collar on the SSP cable connector.

   2. Insert the cable into the connector so that the cable's exposed contacts are facing away from the system rear panel.

   3. Press down on each side of the collar to secure the cable in the connector.

      Figure 6-18  

      
      

2. Insert the SSP card into the SSP rear panel opening.

   The SSP paddle card mounts in the top slot opening in the system's rear panel.

   Figure 6-19  

   
   

3. Secure the SSP card faceplate to the rear panel with the Phillips screw you removed earlier.

   Use a magnetized screwdriver, if possible, to prevent the screw from falling into the system chassis.

4. Reconnect any external cables to the SSP card's external connectors.