Sun Enterprise 3500 System Installation Guide

Connecting the Fiber Cable to the I/O+ Board

  1. Remove the two plastic caps that cover the cable connector on the GBIC module.

  2. Remove the plastic cap covering the ends of the fiber cable.

  3. Connect one end of the fiber cable into the GBIC module installed on the I/O+ board.

    Align the notch in the cable connector with the key notch in the module connector. See Figure 2-9.

  4. Connect the other end of the fiber cable into the GBIC connector on the SPARCstorage(TM) Array (or other storage device with fiber optic interface) rear panel.

    Align the notch in the cable connector with the notch in the connector on the storage device rear panel.

    Figure 2-9 Fiber Cable and Fibre Card Connectors and Ports on the I/O+ Board

    Graphic