Replacing the Front and Side Panels

Replacing the Media Tray and Front Decorative Panel

1. Replace the front decorative (perforated) panel.

   There are eight screws on the top, seven screws on the bottom, and three screws on each side of the front decorative panel.

2. Close the front door of the Enterprise 3500 system.

3. If necessary, connect the SCSI cables to the back of the media tray.

4. Replace the media tray into the chassis opening at the front of the system.

5. Tighten the two captive screws securing the media tray in the chassis.

Replacing the Front Bezel and Side Panels

1. Place the front bezel against the chassis.

   Press the panel into place. See Figure E-5.

2. Replace the side panels.

   1. Place the side panel alongside the chassis

      The top edge of the side panel should be approximately 1 inch higher than the chassis.

   2. Slide the side panel down until it snaps into place. See Figure E-4.

3. Power on the Enterprise 3500 system.

   See the power-on instructions in Chapter 11, Powering Off and On.