Each SBus+ and Graphics+ I/O board has two onboard connectors; each connector accommodates one GBIC (100 MB/sec Fibre Channel).
Locate the GBIC to be removed. See Figure 4-20 or Figure 4-21.
Remove the GBIC from the I/O+ board by compressing the locking tabs located on either side of the card and pulling straight out from the opening in the I/O+ board panel. See Figure 4-22.
Locate the GBIC slot for installation. See Figure 4-20 or Figure 4-21.
Ensure correct orientation for insertion.
The alignment slots are on the bottom of the GBIC. See Figure 4-22.
Insert the GBIC into the I/O+ board panel slot and then push in to firmly seat the card.
An audible click indicates the GBIC is properly seated to the onboard connector.