To Remove DIMMs

1. Power off the workstation using the procedures described in the section, To Power Off the Workstation.

2. Remove the left-side access panel using the procedure described in the section, To Remove the Left-Side Access Panel.

3. Gently lay the system on its right side on a stable, nonslip surface.

4. Identify the location from which you will remove a DIMM.

5. To remove a DIMM press down on the ejector levers at both ends of the DIMM socket (see Figure 3–16).

   This action ejects the DIMM from the socket.

   Figure 3–16 Removing a DIMM

   
   

6. Lift the DIMM and set it aside on an antistatic surface.

7. Choose the next step.

   • If you are installing a new DIMM, see the next section, To Install DIMMs.

   • If you are finished, close the workstation and prepare it for operation using the procedures described in the section, Closing the Workstation and Preparing for Operation.