Sun Logo


Sun Blade 6048 Server Module Product Notes

820-2309-19



Contents

Preface

1. Fixed and Open Issues

2. Hardware Notes and Issues

Hardware Notes

Sun Blade 6048 Modular System 2U Expansion Module Specifications

Light Load Efficiency Mode (LLEM)

Redundant Mode

Non-Redundant Mode

Upgraded Chassis and Midplane Available

Identifying the PCIe 2.0 Midplane

procedure iconsmall spaceView Component Information Using the CLI

procedure iconsmall spaceView Component Information Using the Web Interface

Supported Modules

Cabinet Doors Must Remain Closed During System Operation

Power Supply Redundancy

Hardware Issues

Important Caution for Chassis Midplane Replacement

NEM LEDs (6713414)

Power Supply Connections (6615994) (6576346)

Power Supply Watt Meter Feature Not Available for A231 Power Supplies (6614183)

Power Consumption Is Invalid in ILOM if PSU Side Is Under 25A (6438921)

3. ILOM Notes and Issues

ILOM Notes

Upgrading ILOM Firmware

Enabling and Disabling the Sun Cooling Door

procedure iconsmall spaceTo Configure the Sun Cooling Door Policy Using the Web Interface

procedure iconsmall spaceTo Configure the Sun Cooling Door Policy Using the CLI

ILOM Issues

Issues Specific to ILOM 3.0.6.11

ILOM 3.0.6.11 Requires Both Power Supplies to Be Powered Up (6874117)

Issues Specific to ILOM 3.0.3.32

ILOM 3.0.3.32 Displays Power Assert/Deassert Errors in Event Log (6865366)

Issues Specific to ILOM 3.0

Reset Server Modules Running ILOM 2.0.3.10 After Updating the CMM to ILOM 3.0.3.32 (6813351)

Moving the CMM to a Different Chassis Can Cause Incorrect Product Data (6821052)

Issues Specific to ILOM 2.0.3.10

Cannot Set Netmask When Running ILOM 2.0.3.10 (6766379)

Issues Specific to ILOM 2.0.3.3

Locate LED Does Not Turn on During Chassis Lamp Test (6713569, 6711416)

Issues Specific to ILOM 2.0.3.2

The stop /CH Command in ILOM 2.0.3.2 is Different Than in ILOM 2.0.3.1 (6679679)

General ILOM Issues

/CH/LOCATE Does Not Turn Off When Set to ON Using the ILOM CLI or ipmitool (6695802)

SP Login Through Web GUI Fails After a New IP Address Is Assigned (6745118)

SP Reports Incorrect FM, NEM, and Server Module Removal and Insertion Events (6744044)

The Tempfail LED and Service LED On the Rear of the Chassis Functionality Is Switched (6745875)

Fixed Issues in ILOM 2.0.3.3

The stop /CH Command Lights the Chassis Alert LED (6678328)

SNMP Trap Destination Port Should Be Configurable (6654887)

4. Documentation Issues

Service Processor Information Missing From Installation Guide (6692166)