A P P E N D I X E |
ILOM Reference Information |
This appendix shows some ILOM CLI commands and related information. Topics covered include:
If you require additional information, refer to the following documents:
Your server is configured to operate under an ILOM shell, by default. You can create an ALOM compatibility shell if you prefer to use commands that resemble ALOM CMT commands to administer your server.
1. Log onto the service processor with the user name root.
When powered on, the SP boots to the ILOM login prompt. The factory default password is changeme.
2. Create a user named admin, then set the admin account role to Administrator and the CLI mode to alom.
Note - The asterisks in the example will not appear when you type (enter) your password. |
You can combine the create and set commands on a single line:
-> create /SP/users/admin role=Administrator cli_mode=alom Creating user... Enter new password: ******** Enter new password again: ******** Created /SP/users/admin |
3. Log out of the root account after you have finished creating the admin account:
4. Log into the ALOM CLI shell (indicated by the sc> prompt) from the ILOM login prompt:
Using the ALOM CMT compatibility shell (with few exceptions) you can type commands that resemble the commands of ALOM CMT. It is useful to remember that the ALOM CMT compatibility shell is an ILOM interface. The comparisons between the ILOM CLI and The ALOM CMT compatibility CLI are described in the Sun Integrated Lights Out Manager 3.0 Supplement for Sun Netra T6340 Server Modules, 821-0903.
1. Using SSH, type the IP address of the service processor for your server module.
-> start /SP/console Are you sure you want to start /SP/console (y/n)? y Serial console started. To stop, type #. |
1. Set the CLI mode for root to default, then log out of the ALOM CMT compatibility shell:
The ILOM login prompt is displayed.
2. Then, log in to the ILOM CLI as usual, using an account other than the admin account (such as root).
The admin account cannot be used for the ILOM CLI as long as its CLI mode is set to the value alom.
Using the ALOM CMT compatibility shell (with few exceptions), you can use commands that resemble the commands of ALOM CMT. Remember that the ALOM CMT compatibility shell is an ILOM interface. The comparisons between the ILOM CLI and the ALOM CMT compatibility CLI are described in the Sun Integrated Lights Out Manager 3.0 Supplement for Sun Netra T6340 Server Modules, 821-0903.
1. To switch from the ILOM command line interface (CLI) to the ALOM-CMT compatibility shell, type:
Note - A banner displays the ILOM version, however the sc> prompt, indicates that you are now using ALOM CMT. |
2. To Switch from the ALOM-CMT compatibility shell to the default ILOM command line interface, type:
3. If you are using an ssh session, type ssh to login to the service processor.
1. Type the following commands from the host console:
Note - If you want to use ssh session, you will have to type the ssh command. |
You can connect to any server module service processor through the chassis CMM and the CMM ILOM firmware. The procedure is described in the Sun Netra T6340 Server Module Installation and Administration Guide, 821-0901.
You might also want to consult the ILOM administration or ILOM user’s guide for the chassis CMM that your server module is installed in; for example, the Integrated Lights Out Manager (ILOM) 3.0 Supplement for the Sun Netra 6000 Modular System, 821-0933, 821-0903.
Copyright © 2010, Oracle and/or its affiliates. All rights reserved.