Classifying and Conditioning Ingress Traffic
Define Incoming Packet Priorities
Define the Traffic Classes With the class-map Command
Set the Rate and Burst Tolerance of a Traffic Stream
Classifying and Scheduling Egress Class Traffic
Define the Egress Scheduler Behavior
SEFOS# configure terminal SEFOS(config)# ip access-list extended 200 SEFOS(config-ext-nacl)# permit ip 10.123.1.0 255.255.255.0 any SEFOS(config-ext-nacl)# exit SEFOS(config)# ip access-list extended 210 SEFOS(config-ext-nacl)# permit ip any any SEFOS(config-ext-nacl)# exit
SEFOS(config)# interface extreme-ethernet 0/1 SEFOS(config-if)# ip access-group 200 in SEFOS(config-if)# ip access-group 210 in SEFOS(config-if)# end
SEFOS# show access-lists ip 200 Extended IP Access List 200 ----------------------------- Filter Priority : 1 Filter Protocol Type : ANY IP address Type : IPV4 Source IP address : 10.123.1.0 Source IP address mask : 255.255.255.0 Source IP Prefix Length : 24 Destination IP address : 0.0.0.0 Destination IP address mask : 0.0.0.0 Destination IP Prefix Length : 0 Flow Identifier : 0 In Port List : Ex0/1 Out Port List : NIL Filter TOS : NIL Filter DSCP : NIL Filter Action : Permit Status : Active
SEFOS# show access-lists ip 210 Extended IP Access List 210 ----------------------------- Filter Priority : 1 Filter Protocol Type : ANY IP address Type : IPV4 Source IP address : 0.0.0.0 Source IP address mask : 0.0.0.0 Source IP Prefix Length : 0 Destination IP address : 0.0.0.0 Destination IP address mask : 0.0.0.0 Destination IP Prefix Length : 0 Flow Identifier : 0 In Port List : Ex0/1 Out Port List : NIL Filter TOS : NIL Filter DSCP : NIL Filter Action : Permit Status : Active