Configuring the RIP Topology Example
Configuring the RIP Packet Retransmission Interval and Retry Count
Set the RIP Packet Retransmission Interval and Retry Count
Reset the Retransmission Interval and Retry Count
Configuring the RIP Passive Interface
Enable the RIP Passive Interface
Disable the RIP Passive Interface
Configuring the Default Metric
Managing the auto-summary Option
Disable the auto-summary Option
Enable the auto-summary Option
Configuring Interface-Specific RIP Parameters
Configuring Interface-Specific Authentication
Configuring the RIP Default Route Propagation
Configuring the Version for Receiving RIP Advertisement
Configuring the Summary Address
Configuring the split-horizon Option
This section contains procedures for configuring RIP in SEFOS. See Configuring the RIP Topology Example for descriptions of the topologies that are referenced in the procedures. Before you can configure RIP, you must configure the switches in your environment. To configure switch 1, see Configure Switch 1. To configure switch 2, see Configure Switch 2, and to configure switch 3, see Configure Switch 3. RIP is disabled by default.