Sun B2B Suite eXchange Integrator User's Guide

Protocol-Outbound (ToPartner) Parameter and ACK Settings

This section lists and describes business protocol-outbound=ToPartner parameter settings and corresponding acknowledgment settings. See Figure 5–12.

Figure 5–12 Protocol-Outbound (ToPartner) Parameter and ACK Settings

Protocol-Outbound (ToPartner) Parameter and ACK
Settings

Table 5–1 Business-Duplication Checking

Description 

Settings 

Default 

Whether or not outbound messages are checked for duplication. 

Yes or No  

No  

Table 5–2 Business-Use Encryption

Description 

Settings 

Default 

Whether or not outbound messages are encrypted 

Yes or No  

No  

Table 5–3 Business-Use Signature

Description 

Settings 

Default 

Whether or not outbound messages are electronically signed for authentication 

Yes or No  

No  

Table 5–4 Business-Use Compression

Description 

Settings 

Default 

Whether or not outbound messages are compressed 

Yes or No  

No  

Table 5–5 Business-Expect Acknowledgments

Description 

Settings 

Default 

Whether or not the host is expecting acknowledgement for the request/response 

Yes or No  

No  

Table 5–6 Business - Character Set Encoding

Description 

Settings 

Default 

The character set used to encode the text of the outgoing message; optional 

Leave blank to use the default encoding 

 

A string representing a valid character set encoding, such as ASCII or UTF-8) (or empty) 

(empty) 

Table 5–7 Business - Content Type

Business - Content Type 

Description 

Settings 

Default 

(reserved) 

(reserved) 

(empty) 

Table 5–8 Business - Maximum Number of Resends

Description 

Settings 

Default 

The maximum number of resend tries permitted (optional ) 

Does not apply to acknowledgments 

Nonnegative integer; however, if you are expecting a response or acknowledgment, set this to a positive value 

If this parameter and the following one are both set to 0, then no correlation will be started on the message; consequently, in this case, an incoming response or acknowledgment causes an exception to be thrown 

To turn off business responses only, make sure the acknowledgement value is set to any nonnegative integer, then set the reply time out to 0. 

(empty) 

Table 5–9 Business - Minutes Between Resends

Description 

Settings 

Default 

Number of minutes to wait between resends (optional) 

Does not apply to acknowledgments 

Nonnegative integer; however, if you are expecting a response or acknowledgment, set this to a positive value 

If this parameter and the following one are both set to 0, then no correlation will be started on the message; consequently, in this case, an incoming response or acknowledgment causes an exception to be thrown 

(empty)