JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Blade Storage Module M2 Product Documentation
search filter icon
search icon

Document Information

Preface

Product Information Web Site

Related Books

About This Documentation (PDF and HTML)

Documentation Comments

Change History

Hardware Installation

Overview of the Sun Blade Storage Module M2

System Requirements

Installing the Storage Module Into the Chassis

Storage Module Indicators

Storage Module Front Panel LEDs

Assigning and Managing Storage

Product Notes

Overview of the Sun Blade Storage Module M2 Product Notes

Supported Firmware, Hardware and Software

Hardware Issues

Solaris Operating System Issues

Linux Operating System Issues

Administration

Assigning Storage to Hosts

Managing Storage

Performing Maintenance and Hot Plug Actions

Importing Existing Virtual Drives to a Replacement REM

Storage Module Sensors and Indicators

Troubleshooting

Service

Introduction to the Sun Blade Storage Module M2

Maintaining the Sun Blade Storage Module M2

Diagnosing Storage Module Faults

Specifications

Index

Storage Module Front Panel LEDs

The front panel of the storage module is shown below.

image:Figure showing a front view of the storage module with its LEDs
Figure Number
LED Name
Description
1
Combined Locate button and LED (white)
This LED helps identify which module you are working on in a chassis full of servers.
  • Push and release this button to make the Locate LED blink for 30 minutes.

  • When the Locate LED is blinking, push and release this button to make the Locate LED stop blinking.

  • Hold down the button for 5 seconds to initiate a “push-to-test” mode that illuminates all other LEDs for 15 seconds.

  • This LED can also be made to blink from a remote system using the CMM ILOM. Refer to the Storage Module Sensors and Indicators in Sun Blade Storage Module M2 Administration Guide for details.

2
Indicator not applicable
  • Not used.
3
Module Fault LED (amber)
This LED has two states:
  • On: An event has been acknowledged, and service action is required. This could indicate a problem with the module.

  • Off: Normal operation.

4
Module Status LED (green)
This LED has three states:
  • On: Module is configured and online.

  • Off: Module is not configured or is offline.

  • Blinking: Module is configuring or a firmware flash update is in progress.

5
Disk Drive Activity LED (green)
This LED has three states:
  • On: Power is on and disk is online.

  • Off: Disk is offline.

  • Blinking: Irregular blinking means normal disk activity; steady, slow blink means RAID activity (such as a rebuild).

6
Disk Drive Fault/Locate LED (amber)
This LED has four states:
  • On: Disk fault. Service action required.

  • Off: Normal operation.

  • Slow blink: Disk failure predicted.

  • Fast blink: Locate function activated.

7
Disk Drive Ready-to-Remove LED (blue)
This LED has two states:
  • On: Read to remove.

  • Off: Normal operation.