test

Configuring Java CAPS JBI Components for GlassFish Clustering

ProcedureTo Add a Java CAPS JBI Component to a Cluster

Before You Begin

Make sure the cluster and all server instances are created and running. To verify they are running, select Nodeagent in the left navigation bar on the Admin Console and review the cluster information. Also be sure any libraries on which the component is dependent have been added to the cluster.

Note –

The BPEL SE, IEP SE, and Database BC require additional steps before and after adding them to a cluster in order to configure and create the persistence databases. In addition, most components require some configuration steps. Be sure to review the sections for each component you add before you begin. Links to each section are provided at the end of these instructions.

  1. Launch the GlassFish Admin Console.

  2. In the navigation bar on the left, expand JBI and then expand Components.

  3. Select the name of the service engine or binding component to add.

    The Properties page appears.

  4. Click the Targets tab.

  5. On the Targets page, click Manage Targets.

  6. Under Add to Available Targets, select the cluster to which you are adding the component.

    Figure shows the Manage Targets page for a JBI component.

  7. Configure any runtime properties that appear below the target.

  8. If the component is already added to another cluster or server that it should not be, select that cluster or server under Remove From Installed-To Targets.

    Note –

    Removing some components from the default “server” target removes them from the NetBeans Services window.

  9. Click OK.

    The Targets page reappears.

  10. In the Targets list, select the check box next to the cluster, and then click Start.

    Note –

    Many components require additional configuration or have certain requirements. Refer to the topic for each component for more information. Below is a link to each component: