Documentation, Support, and Training
Understanding the Sun Dual 10GbE PCIe 2.0 Fabric Expansion Module
Power and Environmental Requirements
Hardware and Software Requirements
Installation Overview for Solaris Platforms
Installation Overview for Linux Platforms
Installation Overview for Microsoft Windows Platforms
Verify the Driver Version on a Solaris Platform
Remove the Driver From a Solaris Platform
Download and Install the Driver on a Linux Platform
Remove the Driver From a Linux Platform
Download and Install the Driver on a Microsoft Windows Platform
Remove the Driver From a Microsoft Windows Platform
Installing the Fabric Expansion Module
Install the FEM in a Server Module
Verify the Installation in a Solaris SPARC System
Verify the Installation in a Solaris x86 System
Verify the Installation in a Linux System
Verify the Installation in a Microsoft Windows System
Create /etc/hostname.ixgbe# Files
Boot Over the Network Using PXE
Boot Solaris x86 and Linux Systems Over a 10GbE Network
Install the Solaris OS Over a 10GbE Network on SPARC Systems
Configuring the Driver Parameters
Driver Parameters for the Solaris OS
Set ixgbe Driver Parameters in the Solaris OS
Solaris OS Performance Variables
Improve Performance in the Solaris OS
Set Driver Parameters in Linux
Configure Jumbo Frames in Solaris OS
Configure Jumbo Frames in Linux
Configure Static VLANs in a Solaris Environment
Configure VLANs in a Linux Environment
Use this procedure to configure the network host files dynamically on the command line. At reboot, the settings will revert.
Create a file named /etc/hostname.ixgbe# for each ixgbe interface.
where # is the ixgbe interface instance number you plan to use.
For example, to bring up ixgbe0 at boot, create a file called /etc/hostname.ixgbe0, where 0 is the number of the ixgbe interface. If the instance number were 1, the filename would be /etc/hostname.ixgbe1. The /etc/hostname.ixgbe# file must contain the host name for the appropriate ixgbe interface.
Get the ixgbe instances:
# dladm show-dev
The output might include lines similar to the following:
nxge0 link: up speed: 1000 Mbps duplex: full nxge1 link: unknown speed: 0 Mbps duplex: unknown nxge2 link: unknown speed: 0 Mbps duplex: unknown nxge3 link: unknown speed: 0 Mbps duplex: unknown e1000g0 link: unknown speed: 0 Mbps duplex: half e1000g1 link: unknown speed: 0 Mbps duplex: half ixgbe0 link: up speed: 10000 Mbps duplex: full ixgbe1 link: up speed: 10000 Mbps duplex: full
Use the ifconfig command to set up the FEM’s ixgbe interfaces.
Your ifconfig command might look similar to the following:
# ifconfig ixgbe0 plumb ip_address netmask 255.255.255.0 broadcast + up
ifconfig(1M) man page
Solaris 10 System Administrator Collection