test

SunVTS 3.0 Test Reference Manual

saiptest Error Messages

The saiptest error messages are generated when the SunVTS Serial Asynchronous Interface discovers errors. The error descriptions in the table below identify probable causes for the card or test failure, and identify the Field Replaceable Unit (FRU) and recommended action, if possible. The three FRUs under test are: the Serial Asynchronous Interface card, the 78-pin shielded cable, and the Patch panel

Table 29-4 saiptest Error Messages

Error Message 

Probable Cause(s) 

Recommended Action 

6000

 

error_message

 

 

6001

Expected = value, observed = value

 

 

6002

Expected value:

 

 

6003

Observed value:

 

 

6004

Modem Loopback test failed on device_name

 

 

6005

Off-line error on device device_name

 

 

6007

Busy error on device device_name

 

 

6008

Error on device device_name

 

 

6009

Retry number exceeds limit number rc =s value

 

 

6010

Expected number bytes, observed number bytes

 

 

6011

Internal test failed on device_name

 

 

6012

Data Loopback test failed on device_name

 

 

6013

Ioctl TIOCSSOFTCAR error on device_name

 

 

8000

Must provide device name!

 

 

8001

No SAI/P card found or device driver not installed

 

 

8002

Ioctl TCSETS failed on device_name

 

 

8003

Open error on device_name - device driver may not be installed properly

 

 

8004

Device device_name is already opened

 

 

8005

Ioctl SAIP_ENLOOP error in device_name

 

 

8006

Ioctl SAIP_DISLOOP error in device_name

 

 

8011

Ioctl TIOCMGET failed on device_name

 

 

8012

device_name: Expected DSR set, observed clear

 

 

8013

device_name: Expected DSR clear, observed set

 

 

8014

Ioctl TIOCMSET failed on device_name

 

 

8015

Ioctl TIOCMBIC failed on device_name

 

 

8016

Read error on device_name

 

 

8017

Write error on device_name

 

 

8020

Timeout error on device_name

No loopback plug. 

Check the loopback plug. 

8021

Timeout error on device_name

TTY terminal not connected. 

Check the TTY terminal connected to the device. 

8022

Timeout error on device_name

 

 

.